Q u i c k
Getting Started
Before you can use your SPT 1800, perform the basic setup
procedures:
•
Install and charge the battery
•
Start the SPT 1800
•
Initiate the network connection (184X only).
Installing the Battery
1. Open the latches on the
battery cover and lift it
away from the SPT 1800.
2. Insert the lithium-ion (Li-
ion) battery into the battery
compartment, ensuring
that it snaps into place.
3. Replace the battery cover
and close the latches.
Note:
Keep the battery
latches completely
open while securing
the battery cover.
Charging the Battery
Note:
Use 1700 mAh Lithium-ion battery (p/n 21-58236-01).
Before using your SPT 1800 for the first time, charge the battery
using the cradle, the Synchronization/Charging Cable or the
Universal Battery Charger (UBC). For instructions on using the
UBC, see the UBC Quick Reference Guide.
R e f e r e n c e
Latch
5
Latch