Digital Dubbing - JVC GR DV 3 Instructions Manual

Digital Dubbing

It is also possible to copy recorded scenes from the camcorder onto other video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any image or sound deterioration.
Connector is
under the cover.
To DV OUT
connector
1 CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
2
MAKE CONNECTIONS
Attach the camcorder to the AC Charger
Station referring to step 2 as shown in the
illustration on pg. 53.
Connect the camcorder to your video unit
equipped with a DV connector using the DV
cable (optional) as shown in the illustration.
3
START PLAYBACK
Press the Play button (4) to play back the
source tape.
4
START RECORDING
While watching the playback picture, engage
the DV connector-equipped video unit's record
mode from the spot on the source tape you
want to begin recording.
To AC outlet
Lock!
DV cable (optional)
NOTES:
You cannot use the battery pack installed in the
camcorder as the power supply since a digital
signal is output from the DV OUT connector
only when using the AC Charger Station.
When using the camcorder for dubbing, be sure
to use it as a player. The camcorder's DV
connector is only for output.
If a blank portion is played back during dubbing,
an unusual image may be dubbed.
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If
the above occurs, turn off power and make
connections again.
The image with Digital Zoom, Fade/Wipe Effects,
P.AE/Effects and Snapshot is not output from the
DV OUT connector. Only the original playback
image is output from it.
T W
PLAY
STOP
Video unit equipped
with DV connector
To DV IN
connector
1
59
EN