Wiring Dc Power Inputs - Planet MGSW-28240F Quick Installation Manual

3. Wiring DC Power Inputs

The 6-contact terminal block connector on the rear panel of the MGSW-28240F is
used for two DC redundant power inputs. Please follow the steps below to insert
the power wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2 for DC
POWER 1, or 5 and 6 for DC POWER 2.
ON 100~240V AC
OFF
2. Tighten the wire-clamp screws for preventing the wires from loosening.
The wire gauge for the terminal block should be in the range of 12
~ 24 AWG.
Note
DC POWER
DC Input Range:
50/60 Hz 36V~72V
1 2 3
Fault
DC 1
+ - Alarm
ON
DI 0 DI 1 DO 0 DO 1
OFF
DC 1 Fault
4 5 6
DC 2
+ -
GND GND
Ring R.O.
FAN2 Fault
FAN1 DC 2
PWR DC 1
1
DC 2
5