Ford Expedition 2000 Workshop Manual page 5
Intake manifold — 5.4l
Hide thumbs
Also See for Expedition 2000:
- Owner's manual (256 pages) ,
- Operator's handbook manual (60 pages) ,
- Operation manual (60 pages)
Advertisement
2000 Expedition/Navigator Workshop Manual
30. Remove the upper intake manifold.
1. Lift the intake manifold.
2. Disconnect the intake manifold tuning valve connector.
3. Remove the intake manifold and discard the gaskets.
31. If required, remove the bolts and the water crossover.
Installation
1.
CAUTION: Do not use metal scrapers, power abrasive discs or any abrasive means to clean the sealing surfaces. These tools cause scratches and gouges that
make leak paths. Use a plastic scraper only.
Clean all the sealing surfaces.
2. If removed, install the water crossover.
3. Install the intake manifold.
1. Position the new intake manifold gaskets.
2. Position the upper intake manifold.
3. Loosely install nine bolts.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYJ/~MUS~LEN/20/S...
Page 5 of 10
9/11/2009
Advertisement
