Night Light Replacement; Porcelain Panel Removal; Door Latch Replacement - Napoleon LHD62N Installation And Operating Instructions Manual

48

11.6 NIGHT LIGHT REPLACEMENT

Your appliance came equipped with our "NIGHT LIGHT". The light has been
pre-wired and can be controlled by remote control.
EN
It is recommended that the NIGHT LIGHT be in the off position when the
appliance is on.
If in the event the lamp or lens needs to be replaced, follow the
instructions below.
A. Shut off the electrical supply to the fi replace.
B. Remove the four screws that secure the lens frame. This frame
retains the glass lens. The lamp can now be accessed.
NOTE: Do not handle the lamp (bulb) with bare fi ngers,
protect with a clean dry cloth.
C. The lamp will pull straight out of the socket.
Replace with Wolf Steel parts only, as lamp and lens are
special "high temperature" products.
D. When re-installing, ensure integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
NOTE: Over tightening the screws could break the lens.

11.7 PORCELAIN PANEL REMOVAL

Remove the 2 screws on either top side of the rear porcelain panels.
A.
Pivot the panel forwards and lift out, as shown below.
B.
Remove the 4 screws on both top and bottom of the side porcelain panels
C.
Pivot the panel forwards and lift out, as shown below.
D.

11.8 DOOR LATCH REPLACEMENT

*Prior to replacing the latches follow the "DOOR REMOVAL" process and then follow the media removal
instructions located under the maintenance section.
Remove the media tray by removing all screws securing the front, rear and side panels.
A.
For upper latches: locate the latch you need to replace, ensure to keep a grip on the latch. Begin
B.
removing the 4 screws securing it in place from the inside of the fi rebox, pull latch forward. Install new
latch and ensure it remains secure by tightening the 4 screws.
For lower latches: locate the latch you need to replace, ensure to keep a grip on the latch. Begin
C.
removing the 4 screws securing it in place from the inside of the fi rebox, pull latch forward. To install
the new latch secure the 2 rear screws prior to securing the 2 front screws.
Ensure proper door seal.
D.
W415-1068 / B / 01.02.14
SCREWS
LENS ASSEMBLY
FIREBOX TOP
GASKET
LENS
FRAME