Installing The Swingarm - Yamaha YZF-R1P Service Manual

SWINGARM AND DRIVE CHAIN
6. Check:
• drive sprocket
• rear wheel sprocket
More than 1/4 tooth a wear → Replace the
drive chain sprockets as a set.
Bent teeth → Replace the drive chain
sprockets as a set.
b Correct
1 Drive chain roller
2 Drive chain sprocket
EAS00711

INSTALLING THE SWINGARM

1. Lubricate:
• bearings
• spacers
• dust covers
• pivot shaft adjust bolt 1
• pivot shaft
NOTE:
_
Use the pivot shaft wrench 2 to tighten the
pivot adjust bolt to specification torque.
2. Install:
• relay arm
• connecting arms
NOTE:
_
Install the connecting arm front bolt 1 from the
left.
3. Install:
• rear shock absorber assembly
• rear wheel
Refer to "INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLY" and "INSTALL-
ING THE REAR WHEEL".
4. Adjust:
• drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" in chapter 3.
4 - 75
CHAS
Pivot shaft wrench
YM-01471
Pivot shaft adjusting bolt
5 Nm (0.5 m · kg, 3.6 ft · lb)
45 Nm (4.5 m · kg, 33 ft · lb)
45 Nm (4.5 m · kg, 33 ft · lb)
Drive chain slack
40 ~ 50 mm (1.57 ~ 1.97 in)