Changing Playback Settings; Playback Settings Menu; Audio/Subtitle Settings; Playback Settings - JVC 1010MTH-SW-MT Instructions Manual

Playing Back
Changing Playback
Settings
Displaying the playback settings menu
1 Press the [PB MODE] button on the remote
control unit during the playback of a title
The Settings Menu screen appears.
The playback settings menu can only be displayed during
the playback of a title.
Only settings that are supported by the current title being
played back can be changed in the playback settings
menu.
Items displayed in gray cannot be set.

Playback Settings Menu

Audio/subtitle settings

.
Memo:
"AUDIO/SUBTITLE" will be displayed only if they are
available in the video content. The setting value differs
depending on the content. Items that are not available in
the content cannot be set.

AUDIO LANGUAGE

CHANGE AUDIO OUTPUT

SIGNAL TYPE (BD-ROM)
PRIMARY VIDEO
PRIMARY AUDIO
SECONDARY VIDEO
CHANGE SECONDARY VIDEO
SECONDARY AUDIO
SECONDARY AUDIO LANGUAGE

SUBTITLE LANGUAGE

SUBTITLE STYLE

CHANGE ANGLE

56

Playback settings

.
REPEAT
The following items can be set.
Items are not displayed if they cannot be set.
Setting Values
OFF Turns off repeat.
Repeats playback of the currently played
TITLE
title.
Repeats playback of the currently played
CHAPTER
chapter.
Repeats playback of the currently played
TRACK
track.
Repeats playback within the currently
FOLDER
played folder.
Repeats playback of the entire disc.
ALL
Repeats playback of the section between the
A-B
specified starting and ending points.
Pressing the [OK] button specifies the
displayed scene as the starting point (Point
A). Pressing the [OK] button after forwarding
playback specifies the displayed scene as the
ending point (Point B).
CHANGE TITLE
You can change to a different title by entering the corresponding
numeric value. Any value that is larger than the number of titles
cannot be entered.

CHANGE CHAPTER

You can change to a different chapter by entering the
corresponding numeric value. Any value that is larger than the
number of chapters cannot be entered.
TIME JUMP
You can move to a specific playback position by entering a time.
This is not possible if the specified time is not valid.
SLIDESHOW INTERVAL
The following items can be set.
3SEC/5SEC/10SEC/20SEC/30SEC modes
SLIDESHOW EFFECTS
The following items can be set.
Setting Values
OFF Turns off slideshow effect.
ON Turns on slideshow effect. "Fade out" and
"Fade in" effects can be applied when
switching from one slide to another.
Description
Description