JVC 1010MTH-SW-MT Instructions Manual page 100

Others
Troubleshooting
(Continued)
Problem
Data cannot be
imported
The title/group name
cannot be changed
The remote control
unit does not work
The disc cannot be
ejected
The disc cannot be
played
Output is at 480i
regardless of the
component output
resolution setting
The aspect ratios of
the HDMI output and
component output are
different
100
Symptom
The title to be dubbed is copyright
protected.
The number of titles stored in the HDD
has reached the maximum amount.
The remaining space on the HDD is
running out.
Protection of the title/group name is
turned on.
The battery of the remote control unit
has run out.
The remote control code of this unit
and the remote control unit are
different from each other.
A "LOCKED" message appears on the
display window of the unit.
A "LOCKED" message appears on the
display window of the unit.
The "READING" message does not
disappear from the unit's display
window, and the disc tray does not
open when the [ M ] button is pressed.
A disc that cannot be played on this
unit is inserted.
The region code of the BD or DVD is
different from that of this unit.
An unfinalized DVD disc that is
recorded using another device is
inserted.
The component output setting may be
changed to 480i after viewing at a
setting of 1080/24p using a HDMI
connection.
When two monitors are connected
respectively to the HDMI output and
component output terminals of this
unit, the screen aspect ratio of the
component output may not be
appropriate if "VIDEO PRIORITY
MODE" is set to "HDMI".
Action
Titles that are copyright-protected cannot
be dubbed. Select a title that is not
copyright-protected.
Delete or combine the titles in the HDD to
reduce the amount of titles to less than
500.
Delete the titles in the HDD to increase the
remaining space.
Turn protection off for the title/group name. (A page 64)
Change new batteries for the remote
control.
Change the "REMOTE CONTROL CODE"
for the remote control to the same number
used by this unit.
Disable the "mode lock" setting.
Disable the "tray lock" setting.
Pressing the [ M ] button at the front of the
unit for five seconds or longer opens the
disc tray. To close the disc tray after
removing the disc, press the [ A ] button,
and wait until the tray is closed and power
is turned off.
(If the disc tray does not open after
pressing the [ M ] button for five seconds
or longer, consult our authorized dealer.)
Confirm that the disc is playable on this
unit.
Confirm that the region number is playable
on this unit.
Use that device to finalize the disc.
Turn the power off, and turn it on again.
When two monitors are connected
simultaneously, users are recommended
to set "VIDEO PRIORITY MODE" to
"COMPONENT".
Reference
Page
(A page 23)
(A page 62)
(A page 62)
(A page 16)
(A page 16)
(A page 82)
(A page 82)
-
(A page 10)
(A page 10)
-
-
(A page 80)