Chrysler 300 2010 Owner's Manual page 139

• When you remove the Key Fob from the ignition (or
change the ignition to OFF, for vehicles equipped with
Keyless Go™), the driver seat will move to a position
0.3 in (7.7 mm) forward of the rear stop if the driver
seat position is between 0.9 in and 2.7 in (22.7 mm and
67.7 mm) forward of the rear stop. The seat will return
to its previously set position when you place the
ignition to the ACC or RUN position.
• The Easy Entry/Easy Exit feature is disabled when the
driver seat position is less than 0.9 in (22.7 mm)
forward of the rear stop. At this position, there is no
benefit to the driver by moving the seat for Easy Exit
or Easy Entry.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 139
Each stored memory setting will have an associated Easy
Entry and Easy Exit position.
NOTE: The Easy Entry/Easy Exit feature can be enabled
or disabled through the programmable features in the
EVIC. Refer to "Automatically Move Seat Back on Exit,"
under "Personal Settings (Customer-Programmable Fea-
tures)" under "Electronic Vehicle Information Center
(EVIC)" in Section 4.
3