Pedestal Installation - Frigidaire Dryer Servicing

Washer and Dryer 15" Drawer Pedestal
Installation
The Affinity Series washers and dryers use the same
pedestal.
Tools needed:
Level
9/16" open end wrench
#2 Phillips screwdriver
Washer/Dryer Installation Kit
NOTE
This kit is intended to be installed by persons having
electrical and mechanical training and a level of
knowledge considered acceptable in the appliance
repair trade.

Pedestal Installation

1. Attach the rear brackets to the pedestal with
(4)- #10 screws (2 per bracket).
2. Attach the front brackets and spacer plates to the
pedestal with (4)- #10 screws (2 per bracket).
3. Tilting the dryer back slightly to engage the slots in
the rear of the dryer with the tabs of the rear
brackets on the pedestal.
NOTE
If dryer was previously installed, disconnect power cord
and vent hose. Also, make sure the leveling legs are
adjusted fully into the dryer.
4. Using two or more people, carefully lift the dryer
onto the pedestal, tilting the washer back slightly to
align the holes in the rear of the dryer with the slots
of the rear brackets on the pedestals.
NOTE
If the mounting holes do not align, make sure dryer
leveling legs are adjusted fully into dryer. Turn each leg
tight to the base.
Section 2 Installation Information
Screws
Rear Bracket
Pedestal Top
Screws
Front Bracket
Figure 2-34.
NOTE
Do not remove the foam in the middle of the pedestal.
It reduces vibration noise.
Figure 2-35.
Screws
Rear Bracket
Foam
Front Bracket
2 - Rear Brackets (Washer)
14 - #10 x 1/2" Screws
(Washer / Dryer)
2 - Rear Brackets (Dryer)
2 - Front Brackets
(Washer / Dryer)
2 – Spacer Plates (Washer)
2-19