Reattaching The Door - Frigidaire Dryer Servicing

Reattaching the Door

1. Holding the door in both hands, squarely insert the
"T" post on the back of the hinge into the "T" slot
on the front panel and lower it to align the mounting
holes. (See Figure 2-30)
"T" Slot In
Front Panel
"T" Post On
Door Hinge
Figure 2-30.
2. Rest the opening of the inner door at a 90 degree
angle on the "shoulders" of the hinge cutout gate.
Pivot the inner door down onto the outer door.
(See Figure 2-31)
Figure 2-31.
NOTE
Correctly installed hinge screws will press hinge flush
to front panel. Any gap between hinge and front panel
will cause misalignment of strike to latch.
Section 2 Installation Information
3. Close the door and test operation of hinge, strike
and latch. (See Figure 2-32)
Figure 2-32.
2-17