Section 2 Installation Information
Reassembling the Door
1. Locate and remove the hinge cutout gate from the
outer door assembly. Rotate and move it to the
opposite hole in the outer door. (See Figure 2-26)
Figure 2-26.
2. Rest the opening of the inner door at a 90 degree
angle on the "shoulders" of the hinge cutout gate.
Pivot the inner door down onto the outer door.
(See Figure 2-27)
Figure 2-27.
2-16
3. Replace indented head screws (no. 1-5) removed
earlier. Take care not to strip out the plastic holes.
(See Figure 2-28)
4. Replace pan head screws (no. 6-7) removed earlier.
Take care not to strip out the plastic holes.
(See Figure 2-28)
no. 1-5
Figure 2-28.
5. Locate new metal strike supplied with dryer manuals.
Grip new strike with pliers as shown below. Firmly
insert the strike so it is oriented vertically.
(See Figure 2-29)
Figure 2-29.
no. 6-7