9. Push up and hold the lower chimney cover, and remove the
(2) 4 x 13 mm screws. Slide the lower chimney cover down
onto the top of the range hood canopy.
A. Lower chimney cover
B. 4 x 13 mm screw (2)
C. Upper chimney cover
D. Range hood canopy assembly
10. Replace (2) 4 x 13 mm service screws into storage area inside
range hood blower housing.
A
B
A. 4 x 13 mm service screws (2)
B. Inside area of range hood blower housing
11. Go to "Complete Installation" section.
Make Electrical Connection
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Remove the (2) screws from the top of the electrical box
cover and set the screws and cover aside.
3. Using a T20
protector race panel and set the part and screws aside.
Do not damage the wiring.
A
B
C
D
4. Using a T20
electrical box holding the module plate and the (6) other
screws around the perimeter of the module plate.
®
Torx
®
driver, remove the (4) screws from the wire
A
E
A. Electrical box cover
B. Screws - electrical box cover (2)
C. Wire protector race
D. Screws - wire protector race (4)
E. Electrical wiring
®
Torx
®
driver, remove the (2) screws inside the
B
A. Screws - module top assembly (8)
B. Module plate assembly
C. Range hood module
B
C
D
A
C
11