Reinstall Motor; Make Electrical Connection - Jenn-Air JXI8736DS Installation Instructions And Use & Care Manual

Reinstall Motor

1. Place the motor into the module housing, positioning it with
the large keyholes in motor mounting plate towards the back
of the canopy.
2. Grasping the motor plate, push the motor up into the module
housing. Locate the large keyholes over the motor mounting
nuts, push up against the module top cover, and pull the
motor forward to lock into the small keyholes slots.
3. Use the special
/ " (13 mm) tool and tighten the 4 nuts to
1
2
secure the motor.

Make Electrical Connection

For 3 Prong Grounded Power Cord:
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug 3 prong power cord into a grounded 3 prong outlet
located above the range hood.
12
40"
(101.6 cm)
For Hard Wire from Home Power Supply:
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Remove the terminal box cover.
A. Screws
B. Terminal box cover
3. Disconnect grounded power cord wires from terminal block.
Loosen the screws labeled "L," "N," and "Ground Symbol."
4. Remove power cord strain relief from terminal box and
remove power cord.
A. Power cord
B. Power cord strain relief
C. Location "L" (black wire)
D. Location "N" (white wire)
E. Location ground symbol (green or bare ground wire)
5. Install a UL listed or CSA approved
A
B
A
B
C
D
E
/ " strain relief.
1
2