Honeywell LYNX Touch Series Installation And Setup Manual page 45

Factory Defaults
This procedure resets the programming options to factory-default values.
SCREEN
Comm. Diagnostics
Setup
Communication
The following messages may be displayed:
Message
Default Configuration – Successful!
Default Configuration Failed –
Access Denied
Default Configuration – Try Later!
WWW.DIYALARMFORUM.COM
1. Select "Comm. Diagnostics" The System displays the following options depending upon
the communication device that is installed:
Communication
Status
Communication
ID Numbers
2. Select "Setup Communication". The System advances to the Registration screen and
the following options are displayed:
Register
Device
Update
Server
3. Select "Factory Defaults" and select "Yes" when the confirmation screen appears. The
device is reset to factory default values. Selecting "No" will cancel the operation. (Refer
to the table below for applicable registration messages.)
Indicates all programmed values are reset to the original factory settings.
Error message indicates the device does not have local programming access.
Error message indicates the module is busy.
- 45 -
LYNX Touch Installation and Setup Guide
Programming the Control
ACTION
Ethernet
Information
Test
Communication
Register Device
With PIN
Factory
Defaults
Meaning
GSM
Information
Setup
Communication