Honeywell LYNX Touch Series Installation And Setup Manual page 27

SCREEN
Device Type
Device Type
Select "Device Type". The system displays the following options (dependant upon the Zone):
New
Window
Glass Break
Heat Sensor
Use the down
Temperature
Environmental
Fire
Other
Response Type
Response Type
1. Select "Response Type". The system displays the following options (dependant upon the
Not Used
Zone):
2. Use the down
the previous page.
3. Select Response Type and select "Save". The system will return to the Zone screen
Alarm Report
Alarm Report
Note: This field is for Alarms. If Response Type "Trouble" is set up and Alarm Report is set to
Yes
Select "Report" to toggle between "No" or "Yes". Select "Save".
Chime
Chime
Note: Chime only applies to entry/exit, perimeter and interior zone types.
No
Select "Chime" to toggle between "No" or "Yes". Select "Save".
Supervision
Supervision
Select "Supervision" to scroll between the following options:
Supervised
Hardwire – Normally Open
Hardwire – Normally Closed
Hardwire – End of Line
RF – Supervised
RF – Unsupervised
After making a Supervision selection, select "Save".
WWW.DIYALARMFORUM.COM
Door
Motion Sensor
Smoke Detector
Carbon Mono. Det.
arrow to scroll to the next page of options:
Flood
Medical
Police
Not Used
Entry Exit 2
Interior Follower
24 Hour Silent
arrow to scroll to the next page of options. Use the
24 Hour Auxiliary
Interior With Delay
Carbon Monoxide
Arm Stay
Disarm
Silent Burglary
Resident Response
General Response
"No" the system will still report if Report Alarms was enabled in the Reporter
programming.
- 27 -
LYNX Touch Installation and Setup Guide
Programming the Control
ACTION
Entry Exit 1
Perimeter
Trouble Alarm
24 Hour Audible
Fire No Verification
Monitor
Trouble
Arm Away
No Response
Resident Monitor
General Monitor
Fire With Verification
arrow to return to