Description - Shindaiwa EB8520RT Operator's Manual

1. Spark plug Provides spark to ignite fuel mixture.
2. Starter handle Pull recoil handle slowly until recoil starter
engages, then quickly and firmly. When engine starts,
return handle slowly. DO NOT let handle snap back or
damage to unit will occur.
3. Serial number label Lists model number and serial
number of unit.
4. Air cleaner Contains replaceable air filter element.
5. Choke Choke is located on the side of the air cleaner.
Move choke lever to
starting. Move choke lever to
choke.
6. Purge bulb Pumping purge bulb before starting engine
draws fresh fuel from the fuel tank, purging air from the
carburettor. Pump purge bulb until fuel is visible and
flows freely in the clear fuel tank return line. Pump purge
bulb an additional 4 or 5 times.
7. Fuel tank cap Covers and seals fuel tank.
8. Fuel tank Contains fuel and fuel filter.
position to close choke for cold
position to open

Description

9. Spark arrester - Catalytic silencer / Silencer The si-
lencer or catalytic silencer controls exhaust noise and
emission. The spark arrester screen prevents hot, glow-
ing particles of carbon from leaving the silencer. Keep
exhaust area clear of flammable debris.
10. Shoulder harness Used to support unit on operator's
back. The straps are adjustable.
11. Throttle assembly Used by operator to direct and con-
trol air flow.
12. Ignition switch "SLIDE SWITCH" mounted on top of
the throttle assembly. Push forward to start and run.
Slide back to stop.
13. Throttle trigger Spring loaded to return to idle when re-
leased. During acceleration, press trigger gradually for
best operating technique.
14. Blower pipes Exclusive positive locking system.
15. Flexible pipe Allows for full range of movement.
13
Description