D 04: Audio/Video Status - Motorola DCT 2000 Installation Manual

d 04: Audio/Video Status

This diagnostic displays the audio and video information for the current tuned channel. The
audio and video status OSD is illustrated in Figure B-8:
F i g u r e B - 8
A u d i o / V i d e o S t a t u s - O S D
04 AUDIO/VIDEO STATUS
ADP Lock
Audio Mode
Audio SPDIF
SAP
VP Lock
MPEG Method
A list of the audio video status information is illustrated in Table B-11:
T a b l e B - 1 1
A u d i o V i d e o S t a t u s
St atus Description
ADP Lock The ADP Lock is the Audio Processor locked status. The ADP Lock displays either
YES or NO.
The audio modes of the DCT2000 are:
Audio Mode
The audio SPDIF displays SPDIF modes valid for the DCT2000. The mode is set by the
Audio SPDIF
software application that runs on the DCT. The two modes for a non-SPIDIF DCT are:
The following are SPIDIF configuration modes (K and L DCT models options):
YES
STEREO
IEC958PCM
N/A
YES
MUTE BLACK
N/A
Mono
Stereo
Surround
N/A
IEC958PCM – AC3
1/0 – Right or left front
2/0 – Right front, left front
3/0 - Right front, left front, center
2/1 - Right front, left front / right or left rear
3/1 - Right front, left front, center / right or left rear
2/2 – Right front, left front / right rear, left rear
3/2 - Right front, left front, center / right rear, left rear
LFE - Low frequency effect if "1" signifies Dolby 5.1
D i a g n o s t i c s
LFE 0
D C T 2 0 0 0 I n s t a l l a t i o n M a n u a l
B - 1 3