Table of Contents
Advertisement
VGA Issue
I cannot set my VGA to go higher than 16 color (640x 480).
1.
Make sure that you have installed the VIA 4 in 1 driver.
2.
Install/ re-install the VGA driver.
After wake-up from Suspend to RAM or Standby mode, the screen has no display but
I can hear the hard disk operating
1.
Install VIA 4 in 1 driver.
2.
Check the VGA card manufacturer for driver update, or make sure the VGA card
support Suspend to Ram function.
Audio Issue
How can I disable the on-board Audio?
Go to the SOYO Combo Feature in the BIOS setup, then set the "onboard 6CH H/W audio"
to disable.
I cannot get the sound working on my system.
1.
Check if the speaker wire is connected to the line out connector in the M/B.
2.
Check if the speaker power is powered on.
3.
Install the audio driver supplied on our driver disc.
4.
Check BIOS setup if "onboard 6CH H/W audio" is enabled.
5.
If sound already installed, check our website for audio driver update.
I cannot get the sound working on the 5.1 channel speaker.
1.
Install the audio driver and application. Check driver installation for more info.
2.
Check if the settings in the 5.1 speaker control box are correct, like if you have a
SPDIF connector but the setup in the speaker box is set to analog.
3.
Check if the speaker connection to the M/B is correct.
4.
Make sure the software setup is correct. Check manual for more info.
The sound is working in my system, but when I play CD music from the CD-ROM, I
do not get any sound. What is wrong?
This is because the 3-wire audio cable from the CD-ROM to the on-board CDIN1 connector
in the M/B is not connected. See manual for location of CDIN1.
The sound from my sound card is distorted when Windows start. What is wrong?
If you are using an ISA sound card, please make sure the IRQ needed for the sound card is
set to ' L egacy ISA' in the BIOS. In other word, if your ISA sound card takes IRQ5, then set
IRQ5 to 'Legacy ISA'.
SY-KT333 DRAGON Plus Quick Start Guide
31
Advertisement
Table of Contents
