Vga Issue; Audio Issue - SOYO SY-P4RS350 User Manual

4. Type "awdflash biosname.bin /sn /py".
5. Then reboot.
Or:
1. Download the BIOS from our support website.
2. Copy the BIOS to an empty floppy disk. (No other files on the disk!)
3. Press <ALT> <F2> after memory initialization.
4. The system will now automatically flash and reboot.
Note: That flashing from the BIOS is only possible if you use a normal floppy drive.
It can't flash from any other device.
After flashing the BIOS, my system will not boot-up.
1. Try clearing the CMOS RAM.
2. The BIOS chip is defective due to an unsuccessful flash, contact your nearest
SOYO branch for re-flashing.
Is there a way to reprogram my BIOS after an unsuccessful flash?
There is no other way, you need to send back the BIOS ROM to your nearest SOYO
branch for re-flashing.

VGA Issue

I cannot set my VGA to go higher than 16 color (640x 480).
1. Make sure that you have installed the ATI utility driver set.
2. Install/ re-install the VGA driver.

Audio Issue

I cannot get the sound working on my system.
1. Check if the speaker wire is connected to the line out connector in the M/B.
2. Check if your speakers are powered on.
3. Install the audio driver supplied on our driver disc.
4. Check BIOS setup if "AC97 Audio" is enabled.
5. If sound already installed, check our website for an audio driver update.
The sound is working in my system, but when I play CD music from the
CD-ROM, I do not get any sound. What is wrong?
This is because the 4-wire audio cable from the CD-ROM to the on-board CDIN
connector or AUX connector on the M/B is not connected. See manual for location of
CDIN.
SY-P4RS350 / P4RC350 Quick Start Guide
27