HYOSUNG Comet 250 R User Manual page 30

LIGHT SWITCH
(For
◉ " " position
: The head lamp come on.
◉ "
" position
: The position lamp, meter lamp, tail
lamp and license plate lamp come on.
But, the head lamp not come on.
◉ "
" position
: All lamps go off.
⑤ ⑤
STARTER SWITCH
Use this switch to operate the starting
motor.
With the ignition switch in the "ON"
position, the engine stop switch in the
" " position, and the transmission is in
neutral, pull in the clutch lever and side
stand up and push the starter switch to start
the engine.
CAUTION
Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after several
attempts, check the fuel supply and
igintion system.
(Refer for Page 71)
& )
WARNING
The
is equipped with the side stand ignition
interlock system.
1. If the transmission is in neutral, you
can start the engine regardless of
clutch lever and side stand.
2. If the transmission is not in neutral,
you can only start the engine with
pulling in clutch lever and side stand
up.
Make sure that the side stand igintion
interlock system is working properly
before riding.
30
&