Connecting Your Video Components - Onkyo Integra TX-DS898 Instruction Manual

Connections
: Signal flow
Audio connection cable
Left (white) L
Right (red) R
Digital audio input (optical)
Digital audio output (coaxial)
S Video input
Video input
R (red)
Analog audio
input
L (white)
5. DVD recorder, other digital video
recording device (VIDEO 2)
R (red)
Analog audio
L (white)
output
Video output
S Video output
P
Component video output
P

Connecting your video components

Below is an example of how you can connect your video
components to the TX-DS898. Refer to the diagram above for the
following connection examples.
The flow of the video signals is as follows:
• The signal that comes in from VIDEO IN is sent to VIDEO OUT
and S VIDEO OUT.
• The signal that comes in from S VIDEO IN is sent to S VIDEO
OUT and VIDEO OUT.
• The signal that comes in from COMPONENT VIDEO IN is only
sent to COMPONENT VIDEO OUT. When connecting a video
player to the COMPONENT VIDEO INPUT terminals, be sure
to connect your television to the COMPONENT VIDEO
OUTPUT terminals.
Note:
If only the video connection for the MONITOR OUT is made, even
if the input from each source component is through a component
video connection, the picture will not appear. If only the S video
connection for the MONITOR OUT is made, the picture will not
appear.
Video connection cable
S video connection cable
DIGITAL PRE
OUTPUT R
TENNA
OPT FRONT
1
SUB
AM
2
COAX SURR
1
SURR
BACK /
ZONE 2
FM
2
75
FRONT
3
DIO
L
OPT
SUB
1 PH
SURR
2 CD
SURR
OUT
BACK
3
R
TAPE
4
GND IN
L
DIO
DIGITAL
INPUT
Y
B
R
Component video connection cable
COMPONENT
AUDIO VIDEO S VIDEO
VIDEO
OUTPUT
MONITOR
OUT Y
R L
OUT ZONE 2 P
B
IN DVD P
R
INPUT 1
OUT Y
VIDEO 1
IN P
B
OUT P
R
VIDEO 2
INPUT 2
IN Y
IN VIDEO 3 P
B
IN VIDEO 4 P
R
R L
AUDIO VIDEO S VIDEO
4. Connecting a DVD player (DVD)
If the device is equipped with an S video output terminal, connect it
to the DVD S VIDEO IN terminal with an S video cable. If it does
not have an S video output terminal, connect its video output
terminal to the DVD VIDEO IN terminal using an RCA-type video
connection cable. You do not need to connect to both the DVD S
VIDEO IN and DVD VIDEO IN terminals. If the device has
component video outputs, connect them to one of the
COMPONENT VIDEO INPUT jacks.
With the initial settings of the TX-DS898, the DVD input source
is set for the COMPONENT VIDEO INPUT 1 jack.
If the video connection is made at COMPONENT VIDEO INPUT 2,
this must be changed at the Setup menu: Input Setup → Video Setup
→ Component Video (see page 38).
Using an RCA-type audio connection cable, connect the audio
output terminal on the device to the audio DVD IN jacks on the TX-
DS898. Make sure that you properly connect the left channel to the L
jack and the right channel to the R jack.
If the device has a digital output jack as well, be sure to also connect
it to either a DIGITAL INPUT (COAXIAL) or DIGITAL INPUT
(OPTICAL) jack on the TX-DS898 depending on the type of
connector on the DVD player.
P P
R R
P P
B B
Y Y
Digital audio output (coaxial)
R (red)
Analog audio
output
L (white)
Video output
S Video output
4. DVD player (DVD)
Y
P
B
P
R
Component video output
19