Rear Panel Facilities - Onkyo Integra TX-DS898 Instruction Manual

Rear panel facilities

Here is an explanation of the terminals found on the rear of the TX-
DS898 and how they are used. Before connecting your audio and
video components, be sure to read this section carefully and then
proceed to the explanations on how to connect each individual
component (see page 18).
• Be sure to always refer to the instructions that came with the
component that you are connecting.
• Do not plug in the power cord until all connections have been
made.
• For input jacks, red connectors (marked R) are used for the
right channel, white connectors (marked L) are used for the
left channel, and yellow connectors (marked V) are used for
video connection.
DIGITAL PRE OUT
OUTPUT
R
OPT FRONT
1
SUB
2
COAX SURR
1
SURR
BACK /
ZONE 2
2
FRONT
3
OPT
SUB
1
SURR
2
SURR
BACK
3
R
4
GND
DIGITAL
INPUT
DIGITAL INPUT/OUTPUT
(coaxial and optical)
These are the digital audio inputs and outputs on the rear panel.
There are three digital inputs with coaxial jacks and four with optical
jacks. The inputs accept digital audio signals from a compact disc,
LD, DVD, or other digital source component. For digital output,
there is 1 optical output. The digital outputs can be connected to MD
recorders, CD recorders, DAT decks, or other similar components.
• Since an analog connection must be made when using REC OUT
or ZONE 2, make sure that the connection to the input source is
not digital only, but analog as well.
• When using one of the optical input or output jacks, remove the
protective cap and keep it safely. When the jack is not used,
replace the protective cap.
• When using an optical input or output jack, always use an optical
fiber cable.
14
AUDIO VIDEO
L ANTENNA
MONITOR
R L
CENTER
AM
OUT
IN
FM
OUT
75
VIDEO 1
MULTI CH
IN
INPUT
AUDIO
R L
CENTER
PH OUT
VIDEO 2
CD IN
OUT
IN VIDEO 3
L
TAPE
VIDEO 4
IN
IN
R L R L
AUDIO AUDIO VIDEO
• Insert all plugs and connectors securely. Improper
connections can result in noise, poor performance, or
damage to the equipment.
• Do not bind audio/video connection cables with power cords
and speaker cables. Doing so may adversely affect the
picture and sound quality.
COMPONENT
S VIDEO
VIDEO
OUTPUT
OUT Y
CAUTION:
SPEAKER
IMPEDANCE
4 OHMS MIN. OR
ZONE 2 P
B
6 OHMS MIN.
/SPEAKER
SEE
INSTRUCTION
DVD P
R
MANUAL FOR
CORRECT
INPUT 1 SETTINGS.
Y
CENTER
P
B
SPEAKER
P
R
INPUT 2
Y
P
B
P
R
S VIDEO
COAXIAL
OPTICAL
Improper connection
Inserted completely
FRONT SPEAKERS SURR SPEAKERS
R L R L
SURR
BACK
/ ZONE 2
R L
SPEAKERS
I R 12V TRIGGER
AC INLET
IN
RS 232
OUT
Coaxial cable
Optical fiber cable
Optical digital input terminal
An optical digital input terminal is
equipped with a protection cap. When
connecting, remove this cap. When not
using, put the cap back on the terminal.
MODEL NO.
TX-DS898
AC OUTLETS
AC 230-240 V 50 Hz
SWITCHED
TOTAL 100 W MAX.