Table of Contents
Advertisement
76885_08a_Escalade_ESV_052407.qxd:Escalade_ESV 2007 A
RAINSENSE™ II WINDSHIELD
WIPERS
The Rainsense II windshield wipers
use a sensor to automatically operate
the wipers when needed, depending
on driving conditions and the
sensitivity setting. If the system is
left on for long periods, an occasional
wipe may occur without any moisture
on the windshield to indicate the
system is activated.
The headlamps also will be turned on
automatically when the Rainsense II
wipers are active if the exterior lamp
control switch is in the AUTO position.
Windshield Wiper Controls
The windshield wiper control band
and the rear wiper switch are located
on the multifunction stalk on the left
side of the steering column. The
Refer to Owner Manual for further information.
Driver
Information
control band can be rotated to the
following settings:
(Mist): Activates one wipe.
(Off): Turns wipers off.
(Rainsense Sensitivity Levels):
The position closest to Off is the
lowest sensitivity level, which allows
more moisture to collect on the
windshield between wipes.
(Low): Activates wipers at low
speed setting.
(High): Activates wipers at high
speed setting.
(Washer Fluid): Push the paddle
on top of the lever to spray washer
fluid on the windshield.
HEATED WINDSHIELD WASHER
FLUID
The heated
windshield
washer fluid
system can
help clear ice,
tree sap and
bugs from the
windshield.
Press the
button, located below the climate
controls on the instrument panel,
Safety &
Comfort
Security
5/24/07
2:32 PM
Page 17
to start four automatic heated
wash/wipe/pause cycles. A light on
the button will flash while the washer
fluid is heating, which may take up
to 40 seconds. The remaining
cleaning cycles may take about 20
seconds to occur.
To cancel any remaining cycles, press
the
UNIVERSAL HOME REMOTE
Located in the overhead console,
the Universal Home Remote is a
combined universal transmitter and
receiver that can activate up to three
devices, such as garage door
openers, entry door locks, gates and
security systems.
It's recommended that you read the
instructions in your Owner Manual
completely before attempting to
program any of the three channels
on the Universal Home Remote. The
engine should be turned off when
programming the remote.
Note: Do not use the Universal Home
Remote with any garage door opener that
does not have the "stop and reverse"
(Heated Washer Fluid)
feature or any opener manufactured before
April 1, 1982.
J Reviewed with Customer (Please Check Box)
Entertainment
Convenience
button again.
Performance &
Owner
Maintenance
Privileges
TM
15
Advertisement
Table of Contents
