Table of Contents
Advertisement
76885_08a_Escalade_ESV_052407.qxd:Escalade_ESV 2007 A
After a remote start, the engine will
run for about 10 minutes before
turning itself off, but can be
extended 10 minutes by performing
another remote start sequence at any
time. After two consecutive remote
starts, no additional remote starts are
allowed until the vehicle has been
started with the ignition key.
The vehicle's climate control system
will automatically heat or cool the
vehicle interior to 74°F (23°C), and
adjust the airflow to the defrost
or vent mode depending on
ambient conditions.
Starting the Vehicle
To remote start the vehicle:
1. Aim the RKE transmitter at
the vehicle.
2. Press and release the
button on the transmitter.
3. Immediately press and hold the
(Remote Vehicle Start) button
for about four seconds.
4. When the parking lamps flash,
release the button. The engine will
start and the parking lamps will
remain on. The engine will
continue to run for 10 minutes.
Refer to Owner Manual for further information.
Driver
Information
5. Repeat these steps for a 10-minute
time extension.
When you enter the vehicle after a
remote start, the key must be
inserted in the ignition and turned
to the Run position before driving.
Note: The Remote Vehicle Start feature
will not operate if the key is in the
ignition, a door or the hood is open, or
if the Check Engine light is illuminated
on the instrument panel cluster.
Canceling a Remote Start
If you wish to turn off the engine
instead of driving after a remote
start, perform one of the
following functions:
• Press and hold the
the parking lamps turn off.
(Lock)
• Press and release the Hazard
Warning Flashers button inside the
vehicle. Press the button again to
turn off the flashers.
• Turn the key in the ignition switch
on and then off.
• The engine will automatically stop
when time expires.
Safety &
Comfort
Security
5/24/07
2:32 PM
Page 15
AUTO TURN SIGNAL
The turn signal lever includes an
automatic lane change signal feature.
To signal a lane change, raise or
lower the lever until the arrow on the
instrument panel cluster starts to
flash, and then release the lever. The
turn signal will automatically flash
three times. If the Tow/Haul mode
is selected, the turn signal will
automatically flash six times.
To signal a turn, move the lever all
the way up or down.
INTELLIBEAM™ AUTOMATIC
HEADLAMPS (if equipped)
IntelliBeam uses a digital light sensor
behind the inside rearview mirror to
maximize forward night vision. The
button until
system automatically switches on the
high-beam headlamps when no other
vehicle traffic is present, and switches
to low beam intensity when the
headlamps or taillamps of other
vehicles are detected. The system
operates only when driving over
20 mph (32 km/h).
The system is turned on
automatically when the headlamp
system is set to AUTO and the turn
J Reviewed with Customer (Please Check Box)
Entertainment
Convenience
Performance &
Owner
Maintenance
Privileges
TM
13
Advertisement
Table of Contents
