Table of Contents
Advertisement
(Lock): Press this button once to
lock all the doors. Press twice to also
flash the turn signals twice and
sound the horn once.
(Unlock): Press this button to
unlock the driver's door. Press it
again within five seconds to unlock
all remaining doors.
(Remote Start): This feature can
be used to start the engine from
outside the vehicle.
To remote start the vehicle:
1. Aim the transmitter at the vehicle.
2. Press and release the lock button
on the transmitter.
3. Immediately press and hold the
remote start button for about
four seconds. When the parking
lamps flash, release the button.
The engine will start and the
parking lamps will remain on. The
engine will continue running for
10 minutes.
4. Repeat these steps for a
10-minute time extension. Only
Refer to Owner Manual for further information.
Driver
Safety &
Information
Security
two consecutive remote starts
are allowed. When you enter the
vehicle after a remote start, apply
the brake and push and turn the
ignition knob to the Run position
before driving.
(Trunk): Press and hold this
button for about one second to
release the trunk lid when the
engine is off or the shift lever is in
Park (P). The trunk may also be
opened using the trunk release
button located at the rear of the
driver's door map pocket.
(Vehicle Locator/Panic Alarm):
Press and release this button to
locate your vehicle in a parking lot.
The horn will chirp three times and
the headlamps and turn signal
lamps will flash three times.
To sound the panic alarm, press and
hold the button for three seconds.
The horn will chirp and the turn
signal lamps will flash for 30
seconds. Press the button again to
cancel the panic alarm. The vehicle
must be turned off to use the alarm.
Comfort/
Seats & Mirrors
Convenience
Comfort/Convenience
DAYTIME RUNNING LAMPS (DRL)
Your vehicle's Daytime Running
Lamps (DRL) automatically
illuminate. The sensor that activates
the DRL and the headlights
automatically is located on top of
the instrument panel. Avoid
covering the sensor to ensure
proper light operation.
RAINSENSE™
WINDSHIELD WIPERS
The Rainsense windshield wipers
use a sensor to automatically
operate the wipers when needed,
depending on driving conditions
and the sensitivity setting. If the
system is left on for long periods, an
occasional wipe may occur without
any moisture on the windshield to
indicate the system is activated.
The headlamps also will be turned
on automatically when the
Rainsense wipers are active if the
exterior lamp control switch is in
the AUTO position.
o Reviewed with Customer (Please Check Box)
Audio/
Powertrain &
Personalization/
Maintenance
Communication
5
Owner
Privileges™
Advertisement
Table of Contents
