Fan Speed; Manual Override Controls - Lincoln Navigator 2000 Owner's Manual

Controls and features

Fan speed (

When AUTOMATIC is pressed, fan
speed is adjusted automatically for
existing conditions. You can override
fan speed at any time. To control
fan speed manually, use the
thumbwheel or steering wheel
control to cancel automatic fan
speed operation.
• Rotate the thumbwheel up for higher fan speed or down for lower fan
speed.
• Press the steering wheel control up for higher fan speed or down for
lower fan speed.
The display will show
indicate manual fan operation.
To return to automatic fan operation, press AUTOMATIC.

Manual override controls

The override controls are located at
the bottom of the EATC and allow
you to determine where airflow is
directed. To return to full automatic
control, press AUTOMATIC.
The air conditioning compressor can operate in all modes except FLOOR
and VENT. It will also operate only when required when AUTOMATIC
has been selected. However, the air conditioning will only function if the
outside temperature is about 6°C (43°F) or higher.
Since the air conditioner removes considerable moisture from the air
during operation, it is normal if clear water drips on the ground under
the air conditioner drain while the system is working and even after you
have stopped the vehicle.
Under normal conditions, your vehicle's climate control system should be
left in any position other than MAX A/C or OFF when the vehicle is
parked. This allows the vehicle to "breathe" through the outside air inlet
duct.
46
)
to
OFF
AUTOMATIC
FLR • DEF DEF
OUTSIDE TEMP
MAX A/C VENT PNL • FLR FLOOR
HI
LO
F
˚
AUTO
OFF
F
AUTO
AUTOMATIC
FLR • DEF DEF
HI
LO