Maintenance; Specifications; Error Indicators And Warnings; Cleaning The Cabinet - Sharp HT-SB60 Operation Manual

Maintenance

Cleaning the cabinet

Periodically wipe the cabinet with a soft cloth.
Caution:
●
Do not use chemicals for cleaning (gasoline, paint
thinner, etc.). It may damage the cabinet finish.
●
Do not apply oil to the inside of each component. It may
cause malfunctions.

Error indicators and warnings

When you fail to perform operations properly, the following
messages are displayed on the sound bar.
Display
(Display blinks)
Demo indicator
(blinks red)
(*): Should the same message appear even if the speaker is
unplugged and plugged in, or is set to the stand-by mode
and on again, contact your local dealer where you
purchased the sound bar.
Meaning
●
When there is no input signal.
Play back the connected
equipment.
●
Nonstandard signal. Cannot
be recognized.
●
Signals other than DOLBY
DIGITAL, DTS, Linear PCM
cannot be recognized.
●
Poor connection of the digital
audio input terminal.
●
Turn off the sound bar and
check if the cable is
connected properly.
●
When the protection circuit is
activated.

Specifications

As part of our policy of continuous improvement, SHARP
reserves the right to make design and specification changes
for product improvement without prior notice. The
performance specification figures indicated are nominal
values of production unit. There maybe some deviations
from these values in individual unit.
Sound Bar
Power source AC 120 V ~ 60 Hz
Power
38 W
consumption
Dimension
Width: 54 - 1/2" (1385 mm)
Height: 2 - 7/8" (73 mm)
Depth: 2 - 11/16" (68 mm)
Weight
7.92 lbs. (3.6 kg)
Output power RMS: Total 160 watts
RMS:
Front Left/Right:
80 watts per channel into 4 ohms at
1 kHz, 10% total harmonic distortion
FTC:
Front: (Left/Right):
Minimum 50 watts per channel into
4 ohms at 120 Hz to 20 kHz, 1% total
harmonic distortion
Output
HDMI™ output: (audio/video support up
terminal
to 1080p) x 1
Input terminal Analog input (AUDIO IN): x 1
500 mV / 47 kohms
Optical digital input (OPTICAL):
Square type x 1
HDMI input: (audio/video support up to
1080p) x 2
Type
2 Way speaker system
2 -1/4" (5.7 cm) woofer
1" (2.5 cm) Soft Dome
Maximum
160 W
input power
Rated input
80 W
power
Impedance
4 ohms
Subwoofer
Power source AC 120 V ~ 60 Hz
Power
33 W
consumption
Output power
RMS:
150 watts per channel into 3 ohms at
100 Hz, 10% total harmonic distortion
FTC:
Minimum 110 watts per channel into
3 ohms at 100 Hz, 1% total harmonic
distortion
Type
Subwoofer system
6 - 5/16" (16 cm) woofer
Maximum
300 W
input power
Rated input
150 W
power
Impedance
3 ohms
Dimensions
Width: 5 - 11/16" (144 mm)
Height: 16 - 15/16" (430 mm)
Depth: 12 - 1/16" (306 mm)
Weight
13.42 lbs. (6.1 kg)
E-15