What Wires Do You Have; Prepare Wires - Radio Thermostat CT30 Install Manual

What wires do you have?

find the 'other end' connection for each wire on your heating or air conditioning equipment and read
the label there. Refer to the Wire Reference page at end of install section for better understanding of
wire labels from different HVAC system makers.
IMPORTANT: The CT30 runs on 3 AA alkaline batteries and/or the C wire if available. If you do
not have a C wire you can run a new wire from the HVAC or use a standard 12-24V [AC or DC] wall
transformer. A constant power source is required when using a radio module.
IMPORTANT: If you have both RH and RC you need to
remove the jumper wire between these 2 terminals.

Prepare Wires

Please follow these guidelines for safe and
secure wire connections:
• You will need at least 2.6" of wire for each of your connections to the CT30.
• If you do not have enough wire, splice additional wire to allow enough slack
• Terminals accept wires from 16-22awg.
• Fan out wires below the hole as shown.
• Remove insulation 1/8" from the tip of each wire.
• Take care not to damage the labels for each wire in handling.
Wire Termials
Make sure your wires are labeled. This may require you to
from HVAC
Jumper
System
wire
W
5 4
PG PG
2.6"