Table of Contents
Advertisement
2. ISDN cables
• Connect the ISDN cables to the ISDN connectors on the system.
• Connect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service provider. Your main
number will be the number associated with the socket to which ISDN cable number 1 is connected.
NOTE
S
OME SOFTWARE VERSIONS DO NOT SUPPORT THREE
North America: The system does not have a built-in network terminator. If your wall socket provides you with an ISDN
U-interface, you will need an NT1 between your system and your ISDN line.
W
NOTE
RITE DOWN THE NUMBERS ASSOCIATED WITH EACH OF THE
WILL NEED THEM LATER TO CONFIGURE THE SYSTEM
3a. LAN cable
• To use the system on LAN, connect a LAN cable from the 'Ethernet' connector on the system to your LAN.
3b. Wireless LAN - Insert PC Card
• Remove the "dummy" card by pressing the 'Eject' button next to the slot.
• Insert the Wireless LAN PC Card.
NOTE: Make sure you insert the card in the right direction (see drawing). Push the
card into the slot until the 'Eject' button pops up.
See 'Wireless LAN Settings' for configuration.
TANDBERG Videoconferencing System
ISDN
LINES
ISDN
. Y
LINES
.
11
OU
Installation
Advertisement
Table of Contents
