Faceplate & Fan Installation - Regency Bellerive I200B Owners & Installation Manual

HEATSHIELD, FACEPLATE & FAN INSTALLATION
1) Remove the door from the unit by lifting it up off the hinges.
2) Position the heat shield fl ush against bottom front of fi rebox on
the inside of the unit.
Note: Heat shield must be fi tted into place to protect the fan.
Heat shield
3) Position the faceplate up against the unit by sliding the left side of the
fascia in behind the door hinges and align the 4 screw holes with the
holes in the fi rebox. Secure in place using 2 screws on top.
4) Install the fan fascia by aligning the bottom screw locations with
Fan Fascia
Regency Bellerive Fireplace Insert
the bottom faceplate. See page 13 for fan wiring diagram.
5) Re-install door.
Draft Plate Cover
6) Install the draft plate cover by sliding the tabs into the tab brackets
on the inside top of the fi rebox, ensure the damper control rod fi ts
thru the opening in the draft plate cover.
7) Install knob on damper control rod.
INSTALLATION
Damper
Control Rod
11