Quik-Call Ii Tm Decode Signalling - Motorola JT 1000 User Manual

20
Quik-Call II™ Decode Signalling
A. Description
Q u i k - C a l l I I d e c o d e i s a c o n v e n i e n t w a y f o r a
dispatcher to voice page an individual or group. Quik-
Call II decode also eliminates the need for you to
listen to traffic that is of no concern. This feature is
enabled on a per-channel basis, and available as
individual call, group call, or dual call.
B. Operation
To turn on and operate Quik-Call ll:
A
1.
B
2.
C
3.
4.
Radio Operation
with Features (cont.)
Turn the radio on.
Activate Quik-Call II by placing the 3-position
t o g g l e s w i t c h i n t h e ( A ) p o s i t i o n ( i f s o
programmed), or by rotating the channel
selector to the desired channel with Quik-Call ll
programmed. The display will show QC.
When a page is received, the LED flashes green,
the call-received annunciator flashes, and an
i n t e r r u p t e d a l e r t t o n e ( i n d i v i d u a l c a l l ) o r
continuous alert tone (group call) is heard. A
voice message will follow. The LED will continue
to flash for the entire length of the message.
Return the radio to the Quik-Call II paging mode
by pressing the monitor button. If the monitor
button is not pressed, the radio will "auto-reset".
The Quik-Call II feature is factory programmed
for auto-reset. When carrier is detected, the
automatic reset timer is stopped; when carrier
is lost, the auto-reset timer is started over.
Notes:
• Quik-Call II auto-reset is cancelled when the
monitor button is pressed or when the
channel is changed. The auto-reset timer is
started over if it was running when a Quik-Call
I I w a s d e c o d e d , o r w h e n a s u c c e s s f u l
transmission was initiated.
• Quik-Call II will be decoded and an aler t
generated regardless of the
squelch configuration on that channel.
PL or DPL