Table of Contents
Advertisement
4
TSTBM3H2CPH6W-A
Days of the week and time. Flashes ambient
humidity level. May also flash outside temperature
when used with TSTBM-OTS--TW-A. OUTDOOR will show.
Programmable Time
Period Icons:
This thermostat has
4 programmable
time periods per day.
Temperature:
Indicates the current
system temperature.
Humidity:
Shows the humidity target
setpoint settings and keys.
Clean Display:
Pressing CLEAN DISPLAY
will allow 30 seconds to clean
the display. The keys will be
inoperable during this time.
CLEAN will appear if your
contractor has programmed a
filter change reminder. Press
CLEAN when filter has been
replaced to reset the filter
change reminder timer.
1
inStAllAtion tiPS
7
reMoving tHe PrivAte lABel BAdge
On the back of the thermostat insert 2 AA Alkaline
batteries (included).
Pull the thermostat directly away from the wall to
Gently slide a scredriver into the bottom edge of the
access the batteries. A firm tug will be required
badge. Gently trun the screwdriver counter
to remove the thermostat from the subbase
clockwise. The badge should pry off easily. do not
mounted on the wall.
use force.
All Bosch thermostats use the same
universal magnetic badge. Contact your local
Bosch distributor to learn more about our
free private label program.
6 720 220 376
Low Battery Indicator:
Program Menu Options:
Replace batteries when
Shows different options
2
this indicator is shown.
during programming.
Wireless Icon
4
Caution
Subject to change without prior notice
REMOTE indicates a remote
has control of the system.
HOLD is displayed when thermostat
program is permanently overridden.
Displays the user selectable
setpoint temperature.
System operation indicators:
COOL
HEAT
The COOL, HEAT or FAN icon will display
when the COOL, HEAT or FAN is on.
NOTE: The compressor delay feature is
active if these icons are flashing. The
compressor will not turn on until the
5 minute delay has elapsed.
Additional Stages of Heating or Cooling;
+1 represents 1 additional stage of
cooling or heating (2 total); +2 means
2 additional stages of heating (3 total)
System Information:
Shows which zone or zones are
controlling your system. Shown only
when one or more indoor sensors
TSTBM-RRS--TW-A are connected.
WAll loCAtionS
The thermostat should be installed approximately 4
to 5 feet above the floor. Select an area with average
temperature and good air circulation.
Do not install thermostats in locations that are:
• On an exterior wall
• In direct sunlight
• Where there may be concealed chimneys or pipes
behind the wall
• Close to a window or door leading outside
• Close to objects radiating heat such as fireplaces,
lighting, space radiators, or any other appliance
• In areas that do not require conditioning
• In dead spots or where drafts can occur (behind
doors or in corners)
• Close to hot or cold air ducts
Pick an installation location that is easy for
the user to access. The temperature of the
location should be representative of the
building.
installation tips
FAN
Revised 02-13
Hide quick links:
Advertisement
Table of Contents
