Table of Contents
Advertisement
Notes regarding installation
The standards and directives applicable in your
country must be observed during planning,
set-up, operation and maintenance.
The device is part of the building installation.
Operation of the device is only permitted
at 230 V/50 Hz AC voltage. Work on the
230 V network may only be carried out by an
electrician. The applicable accident prevention
regulations must be observed here. To avoid
an electric shock on the device, please switch
off the mains power. Failure to observe the
installation instructions may result in fire or
other hazards.
Mounting must be carried out following the
applicable requirements. Failure to observe the
requirements may result in damage to property
and/or injury, or even danger of death.
Please also note any additional information on
the product.
A 230 volt alternating current power supply is
required for this product (the device must have
a phase and neutral conductor).
The product is only intended for fixed
installation in in-wall switch boxes with a
minimum depth of 35 mm and a screw distance
of 60 mm (in accordance with DIN 49073-1) in
indoor areas.
The supplied wire bridge (connection "COM"
and "L" connections) may only be installed with
230 V
consumers. Non-observance can lead
AC
to destruction of the device, fire or electrical
accident!
When connecting the device terminals, ensure
that permitted wires and wire cross sections
are used.
Advertisement
Table of Contents
