Table of Contents
Advertisement
Status LED
The LED indicates the status of the Network Camera�
Item
Steady Red
1
Red LED unlighted
Steady Red + Blink Green every 1 sec�
2
Steady Red + Green LED unlighted
3
Steady Red + Blink Green every 2 sec�
4
Blink Red every 0�15 sec� + Blink Green every 1 sec�
5
Blink Red every 0�15 sec� + Blink Green every 0�15 sec�
Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the reset button with a paper clip or thin object� Wait for the Network
Camera to reboot�
Restore: Press and hold the reset button until the status LED rapidly blinks� It takes about 30
seconds� Note that all settings will be restored to factory default� Upon successful restore, the
status LED will blink green and red during normal operation�
MicroSD/SDHC Card Capacity
This network camera is compliant with
Micro
standard
SD cards�
LED status
Reset Button
Micro
Power on and system booting
Power off
Network works (heartbeat)
Network fail
Audio mute (heartbeat)
Upgrading firmware
Restore default
Status LED
SD/SDHC 16GB / 8GB and other preceding
VIVOTEK
Description
User's Manual - 9
Advertisement
Table of Contents
