Appendix; Troubleshooting; Status Led; Reset And Restore - Vivotek IP7138 User Manual

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

Appendix

A. Troubleshooting

Status LED

The following table lists the LED patterns in general.
Condition
Loading system after power on
During booting procedure
Detecting and setting network
After network is setup (system up)
During the upgrade firmware process

Reset and restore

There is a button in the back of the Network Camera. It is used to reset the system or
restore the factory default settings. Sometimes resetting the system sets the system
back to normal state. If the system problems remain after reset, restore the factory
settings and install again.
RESET: Click on the button.
RESTORE:
 - User's Manual
LED color
Steady green and blink red (once)
Steady green
Steady orange (green + red) till IP address
is confirmed
Blink green / orange every second and
steady red
Blink green / orange every second and fast
blink red
- 56 -
www.vivotek.com