Lan Issues - SOYO SY-P4VGM V1.0 Quick Start Manual

SY-P4VGM V1.0 Quick Start Guide
Added PCI Audio Card does not work on this motherboard.
1. Go to "Integrated Peripherals\VIA Onchip PCI Device" and Disable "AC97 Audio".
2. Go to integrated peripherals and Disable "Game port address" and "Midi port address".
Hard disk/FDD/ CD-ROM issues
My Western digital HDD is not detected during boot-up
Change the jumper settings to cable select or single.
Sometimes the system finds my CD-ROM, sometimes not
1. Check CD-ROM if it is working properly.
2. The power supply might not have enough wattage to support all the peripherals. If your
system has other peripherals connected, like CD-RW, extra HDD, etc. disconnect them.
When I boot up my new computer I get "floppy boot failure" and the LED on the
floppy stays on
1. Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don't
trust the "key lock" or "notch") and use the end-connector of the cable (don't use middle
one).
2. Some floppy drivers have their own jumper to make the same twist as the twist on the
cable. Make sure this jumper is set not to "twist" the cable while the floppy drive is
connected to the twisted end of the cable.

LAN Issues

During LAN driver installation, the system hangs on 75%, why?
Enable the onboard LAN in the BIOS setup.
I have problems installing Novell NetWare v.50
Disable the APIC option in the BIOS.
For updated FAQs, please check
http://www.soyousa.com/faqs.html
http://www.soyo.com.tw/faq.htm
26
or