Changing The Movie Settings - Pentax MX-1 Operating Manual

1
Press the Movie button in still-picture capture mode.
Recording starts.
2
Press the Movie button.
Recording stops.
• When recording starts using the Movie button, the number of recorded
pixels is fixed to 1920×1080 and the frame rate 30 fps.
• [Movie SR] (Movie Shake Reduction) is fixed to O (On).
• The recorded area of a movie becomes smaller, both horizontally and
vertically, than the image shown on the display before recording.

Changing the Movie Settings

Change the movie settings in the [C Movie] menu.
1
Press the 3 button in movie mode.
The [C Movie 1] menu appears.
2
Use the four-way controller (23)
to select an item and change its
setting.
3
Press the 3 button after changing the setting.
The setting is saved and the camera returns to capture status.
Movie button
1
Custom Image Custom Image
Recorded Pixels Recorded Pixels Full
HD
Movie SR Movie SR
Wind Suppression Wind Suppression
Enable Autofocus Enable Autofocus
Enable Optical Zoom Enable Optical Zoom
Exit Exit
MENU
2
117