Hearth Mount - Hearth and Home Technologies SMART-BATT-II Installation And Operating Instructions Manual

HEARTH MOUNT

The remote receiver can be placed on the fi replace hearth
(see Figure 1), or under the fi replace behind the control
access panel. Position it close to the front in the right or left
corner where the ambient temperature inside the receiver
case does not exceed 120
NOTE: The remote receiver will only respond to transmitter
when the switch cover on the receiver is in the REMOTE
position. If the system does not respond to the transmitter,
see MATCHING SECURITY CODES, and recheck battery
position in the remote receiver.
RECEIVER WIRING INSTRUCTIONS
Incorrect wiring connections WILL cause damage to the
gas valve or electronic module operating the gas appliance
and may also damage the remote receiver.
Make sure the remote receiver switch is in the OFF position.
Use 18 gauge stranded wires for connections between the
terminal wiring block on the millivolt gas valve or electronic
module and the wire terminals on the remote receiver. For
best results, use wire measuring no longer than 20 ft.
Wiring Millivolt Valves
Connect the remote receiver by connecting each of the
two wires leading from the TH terminals on the gas valve
(see Figure 2) to either of the two wire terminals on the
receiver. Normally it does not matter which wires go to
which terminal.
Alternative Wiring for units with a Wall Switch
A. Wiring Millivolt Valve with Rocker
PILOT
THERMOCOUPLE
VALVE
Figure 3
Hearth & Home Technologies • SMART-BATT-II Remote Control Instructions • 100-909 Rev. i • 5/12
2
0 F.
WHITE
ON/OFF
REMOTE SLIDE SWITCH
Figure 1. Remote Receiver
REMOTE
RECEIVER
Figure 2. Wiring Millivolt Valves
PIEZO
RED
WIRE
TERMINALS
TERMINAL BLOCK
ON MILLIVOLT GAS VALVES
TH
TP TH
TP
WALL THERMOPILE/
PILOT LIGHT
SWITCH
3-ROCKER SWITCH
ASSEMBLY