Operating Instructions For Analog Clock/Timer; Setting Time Of Day; Setting Minute Timer; Setting Oven To Stop Automatically - Amana AGS730 Service Manual

Clock Timer Operation
!
WARNING
Analog Clock
Operating Instructions for
Analog Clock/Timer

Setting Time of Day

1. Push in the set knob.
2. Rotate the knob to the desired time of day.

Setting Minute Timer

1. Rotate set knob till pointer is set at desired time up
to 60 minutes.
2. Buzzer will sound when time has elapsed. Rotate
set knob for pointer to turn off buzzer at OFF .

Setting Oven to Stop Automatically

1. Place the food in the oven.
2. Check the clock and make sure it is set at the cor-
rect time of day.
3. Set the selector to timed bake and temperature
knob to the desired settings.
4. Push in and set the STOP knob to the desired stop-
ping time. When the clock reaches the stopping
time the STOP knob will pop out and the oven will
automatically turn off.

Setting Oven to Start and Stop Automatically

1. Place the food in the oven.
2. Check the clock and make sure it is set at the cor-
rect time of day.
3. Set the selector to timed bake and temperature
knob to the desired setting.
4. Push in and turn the START knob to the desired
start time.
5. Push in and turn the STOP knob to the desired
start time.
To avoid the risk of electric shock, personal injury or death, disconnect power To avoid the risk of electric shock, personal injury or death, disconnect power
To avoid the risk of electric shock, personal injury or death, disconnect power To avoid the risk of electric shock, personal injury or death, disconnect power To avoid the risk of electric shock, personal injury or death, disconnect power
before servicing, unless testing requires it. before servicing, unless testing requires it. before servicing, unless testing requires it. before servicing, unless testing requires it. before servicing, unless testing requires it.
When the clock reaches the starting time the START
knob will pop out and the oven will automatically turn
on. When the clock reaches the stopping time the
STOP knob will pop out and the oven will automatically
turn off.
Turn all controls to off after cooking is finished.

Setting Self-Cleaning Cycle

1. Turn the oven selector knob to CLEAN .
2. Make sure the clock is set at the correct time of
day.
3. Set the start time by using the start time knob.
4. Set the stop time by using the stop time knob.
Suggested length of self cleaning cycle is two
hours minimum, four hours maximum.
5. Close and lock oven door by moving latch lever to
the far right lock position.
6. When the clock reaches the stopping time, the
STOP knob will pop out and the cleaning cycle will
automatically turn off.
7. When the oven has cooled, unlock latch lever (by
moving fully to the left) and open the door.

Clock Switch Function Chart

TERMINALS DELAY
1-2 OPEN
3-4 OPEN

Electronic Range Control III

The ERC III differs slightly from previously used ERC
units in operation, failure codes, sensor resistance and
appearance. The ERC III is housed in a black plastic
enclosure for protection, mounting and retention of
actuator buttons. Refer to the appropriate parts catalog
or wiring diagram to determine which ERC is being
used. The ERC III will have a label identifying the service
part number, manufacturer's part number (i.e. 100-546-
01 with the last two digits representing revision
number), cooking temperature/clean temperature limits
and the manufacturer's date of manufacture.
21
COOK OFF
CLOSED OPEN
CLOSED OPEN
RB231001 Rev. 4