Manual Operation - Rinnai JEPH-10DTW Customer Operation & Installation Manual

MANUAL OPERATION

6
To turn the heater on and set the temperature:
Ensure heater is plugged in and the power socket outlet is switched on.
1. Turn the main power switch
LCD Display will illuminate briefly and a double beep will be heard.
B
2. Press the power button
indicator will illuminate. The two digits
6
setting. The factory setting temperature is 21°C.
3. To change the temperature setting press the MODE button
flash as shown.
If after 5 seconds no buttons are pressed the °C indicator will stop flashing and the display will
revert back to the current operating setting. Simply press the MODE button
NOTE
temperature setting operation.
Press the 'Up'
5
temperature setting range is from 5°C to 30°C.
4. To exit the temperature setting operation either press the MODE button
selected temperature will now be set and displayed.
If the selected temperature is above that of the current room temperature the red operation indicator
illuminate and the heater will begin to heat the room.
If the selected temperature is less than that of the current room temperature the red operation indicator
go out and the heater will go into a standby state until the room temperature has fallen below the set
temperature, when the heater will then automatically switch on and heat the room.
5. To stop heater operation completely press power button
During the initial burning in period some light grey smoke and smell may be experienced. This is
normal and is caused by the burning of oil and dust from the manufacturing process. During this
IMPORTANT
period the space being heated should be well ventilated.
Rinnai Australia
HOW TO OPERATE THE HEATER
A B
8
9
located on the right hand side of the appliance to the on position. The digital
1
on the control panel console
2
or 'Down' buttons to increase or decrease the temperature setting. The available
4
5 4
3 2
to start heating operation. The red operation
A
on the display panel will show the programmed temperature
8
. The °C indicator
3
.
2
3
A
1
on the display panel will
9
to re-enter
3
twice or wait 5 seconds. The
3
Operation Manual
will
6
will
6