Char-Broil Commercial Series Assembly, Use And Care Manual page 12

CA CA
CA CAUTION CA
• Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety reasons.
• Do not use water on a grease fire. Personal injury may
result. If a grease fire develops turn knobs and LP tank
off.
• Do not leave grill unattended while preheating or
burning off on high. If grill has not been regularly
cleaned a grease fire can occur that may damage the
product.
Ignitor Lighting
Do not lean over grill while lighting.
1. Open lid during lighting
2. To ignite any burner, turn knob to HI, push and hold
ELECTRONIC IGNITOR button for 5 seconds.
3. If ignition does not take place within 5 seconds, turn all
burner knobs to OFF, wait 5 minutes, then repeat lighting
procedure.
4. If IGNITOR does not work, follow match lighting
instructions.
Match Lighting
Do not lean over grill while lighting.
1. Open lid during lighting.
2. Place lit match into match
lighting stick, then into lighting
hole on right side of grill.
3. Push in and turn far right burner
knob to HI. Be sure burner lights
and stays lit.
4. Light adjacent burners in sequence by pushing knobs in
and turning to HI.
WARNING WARNING WARNING
WARNING WARNING
• If burner does not light turn knobs to OFF, wait 5
minutes, try again.
Match Lighting
1. To match light SIDEBURNER, open
sideburner cover.
2. Place lit match near burner.
3. Push in and turn sideburner
knob counter-clockwise. Be
sure burner lights and stays lit.
12 • 463231603
UTION UTION
UTION UTION
Burner Flame Check
• Remove grates and flametamers. Light burners, rotate knobs
from HI to LOW. You should see a smaller flame in LOW
position than seen on HI. Always check flame prior to each
use. Perform flame check for sideburner. If only low flame is
seen refer to "Sudden drop or low flame" in
the Troubleshooting Section.
Turning Grill Off
• Turn all knobs to OFF position. Turn gas OFF at gas
source.
Ignitor Check
• Turn gas off at gas source. Push and hold electronic
ignitor button. "Clicks" should be heard and spark seen
each time between collector box or burner and electrode.
See "Troubleshooting" if no click or spark.
Valve Check
• Important: Make sure gas is OFF at gas source before
checking valves. Knobs lock in OFF position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs don't spring back, replace valve assembly
before using grill. Turn knobs to LOW position then turn
back to OFF position. Valves should turn smoothly.
Hose Check
• Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only valve/
hose/regulator specified by manufacturer.
Cleaning The Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1. Turn gas off at control knobs and Gas source.
2. Remove cooking grates, flametamers, grease tray and grease
receptacle.
3. Remove cotter pins from beneath each burner "foot" using a
screwdriver or needle nose pliers.
4. Carefully lift each burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well)
into a small hook. Run the hook through each burner tube
and burner several times.
H I
LOW