Replacing The Tpm Module (Select Models) - Gateway Convertible Service Manual

Replacing the TPM module (select models)

"Replacing the TPM module (select models)" on page 67
Tools you need to complete this task:
v
Screws removed during this task:
To replace the TPM module:
1
2
3
4
5
6
7
66
Replacing convertible notebook components
Important
If the TPM module is not located in the wireless bay, use the procedure found in
Flat-blade driver
Phillips #0 screwdriver
2 black 2.0*2.5 (TPM
module)
Complete the steps in "Preparing the convertible notebook" on page
Open the wireless bay by following the instructions in
card" on page 16.
Remove the two screws that secure the TPM module to the system board.
Lift the TPM module from the system board.
Install the new TPM module onto the system board.
Replace the TPM module screws removed in
Replace the wireless bay cover, then tighten the cover screw.
to replace the TPM module.
- OR - Scribe or non-marring tool
"Replacing the IEEE 802.11 wireless
Step 3.
5.
Screw
Screw