Elation Elar Quad Par User Manual page 21

DMX Address Setting Via Controller
With this function, you can adjust the desired DMX-address via an external controller.
This function can only be activated when the DMX-value of all other channels is set to "0" on
the controller.
1. Select "EBOC" by pressing [UP] or [DOWN] buttons.
2. Press [ENTER], the display shows "ON" or "OFF".
3. Press [UP] to select "ON" if you wish to enable this function or [DOWN] to select "OFF".
4. Press [ENTER] to confirm or press [MENU] to return to main menu.
On the controller, set the DMX-value of channel 1 to "7".
Set the DMX-value of channel 2 to "7"or "8". When set to "7" you can adjust the starting
address between 1 and 255. When set to "8" you can adjust the starting address between
256 and 510.
Set the DMX-value of channel 3 to the desired starting address. If you want to set the
starting address to 57, set channel 1 to "7", channel 2 to "7" and channel 3 to "57". If you
want to set the starting address to 420, set channel 1 to "7", channel 2 to "8" and channel 3
to "164" (256+164=420).
Wait for approx. 20 seconds and the unit will carry out a reset. After that, the new starting
address is set.
Program Run, Master Setting
With the function "RUN", you can run the internal program. You can set the number of steps
under Step. You can edit the individual scenes under Edit.
1. Select "ALON" or "MAST" by pressing [UP] or [DOWN] buttons.
2. Press [ENTER] to confirm or press [MENU] to return to the main menu.
Display The DMX-Value, Reverse Display, Shut Off LED Display
21
w w w . e l a t i o n l i g h t i n g . c o m
ELAR Q UAD P AR
U ser M anual 2 .0
™