Holland Maverick BH421AG6 Instruction Manual page 9

5A
5B
5C
5D
Step 6. MAVERICK ONLY
Lid Handle, Control Knobs & Drip Pan Drain
Select the following parts for assembly:
1. handle bracket
2. grill spring handle
3. assembled drip pan
A. Fasten the handle bracket to the grill lid using 2-1/4-20 x 1/2 Hex
Head Bolts and lock washers. Tighten securely.
B. Place the spring handle onto the studs of the handle bracket studs
by compressing it and sliding into place.
C. Install the two control knobs. Red gas control knob. Black igniter
knob. Push the black knob until it clicks.
Assemble the Drip Pan (use hardware in small plastic bag)
D. Place the assembled drip pan into grill bottom. Line up the drain
pipe with the hole in the grill bottom making sure pipe extends out
bottom and drip pan is setting level. Now place your cooking grid
into the grill.
Maverick only
(Step 6. Wrangler on next page)
4. control knobs
5. drip bucket
Tank Installation: MAVERICK & WRANGLER
Place your 20-lb propane tank into the hole in cabinet base.
Connect the regulator and hose assembly to the propane tank valve.
This connection is made by the QCC-1 fitting. The large black plastic
nut fits over the outside of the tank valve threads and turns right or
clockwise to tighten. No tools are needed. Hand tight is sufficient.
If a good connection is not achieved, the safety valve inside will not
permit the proper amount of gas to flow.
Next attach and adjust downward the Tank- Hold-Down bracket to
secure the tank. Secure with the 1/4-20 x 5/8 Thumb screw.
Check all bolts
and nuts for
tightness and
then proceed
to leak testing.
Tank Hold down
Bracket and thumb
screw
6A
6B
6C
6D
www.hollandgrill.com M&W-6