Holland Maverick BH421AG6 Instruction Manual page 7

Maverick & Wrangler
Step 1. Open Boxes MAVERICK & WRANGLER
On a flat surface (table or garage floor), OPEN AND EMPTY BOTH
BOXES. REFER TO THE CONTENTS LIST TO BE SURE NO PARTS
ARE MISSING. Tighten all factory installed fasteners that may have
loosened during shipping.
Step 2. MAVERICK & WRANGLER
Assemble Grill Base
Select the following parts for assembly:
1. grill base
2. casters (4 ea)
A. Lay base assembly on its back or side. Insert caster into hole on
base assembly, use 3/8" flat washer, lock washer and nut to secure.
Tighten securely. Repeat for other 3 corners. NOTE: Locking casters
go on the front. Lock the casters to prevent cabinet from
moving around during assembly.
B. Turn the grill base back over so the casters are on the floor. Attach
the base pedestal to the grill base using 8-1/4-20 x 1/2 Hex Head Bolts
and lock washers. Tighten securely.
C. Attach the two corner braces to the grill pedestal using 4-1/4-20 x
1/2 Hex Head Bolts, lock washers and nuts. Make sure the large
oblong drain pipe hole is away from the base pedestal. See image 2C.
Finger tighten only.
3. base pedestal
4. corner braces (2)
Step 3. MAVERICK & WRANGLER
Assemble Grill Bottom Shell
Select the following parts for assembly:
1. grill bottom shell
2. bucket hanger bracket
A. Select one of the shelf brackets and bolt it to the grill bottom end
panel using 1/4-20 x 1/2 Hex Head Bolts and lock washers. At this
point, finger tighten only. Repeat for each of the 3 remaining brackets.
B. Position the shelf onto the brackets as shown. Using 10-24 x 1
Carriage Bolts, lock washers and nuts, tighten securely to brackets.
Now securely tighten shelf brackets. Repeat for opposite side.
C. Insert the bucket hanger bracket into the slot and secure with one
#10 - 24 x 3/8" Pan Head Phillips bolt and lockwasher. Secure tightly.
2A
2B
2C
3. shelf brackets (4 ea)
4. shelfs (2 ea)
www.hollandgrill.com M&W-4