Holland Maverick BH421AG6 Instruction Manual page 10

6A
6B
6C
6D
Step 6. WRANGLER ONLY
Lid Handle, Control Knobs & Drip Pan Drain
Select the following parts for assembly:
1. handle bracket (2)
2. handle
3. chip tray and bracket
4. drip pan
A. Select the two handle brackets and handle. First attach the brackets
to the lid using 10-24 x 1/2" Carriage Bolts, lock washers and hex nuts.
You will find them in a separate small plastic bag. DO NOT FULLY
TIGHTEN AT THIS TIME.
B. Now place the tube handle between the handle brackets and
secure with 1/4-20 x 1" Round Head Phillips screw and lock washer as
shown. Tighten both sides completely.
C. Now go back and completely tighten the handle brackets to the lid.
D. Select the chip tray bracket. Attach the bracket to the inside of the
grill using 2 #10-24 x 3/8" Pan head Phillips bolts lock washers and
hex nuts. Slide the chip tray into place by tilting the knob upwards.
E. Select the drain pipe and the drip pan. Install the drain pipe into the
female threaded coupling of the drip pan. Tighten securely by hand.
F. Open the grill lid and Insert the drip pan into place using the lift tabs
on the inside edge. Line up the drain pipe with the hole in the grill
bottom and make sure the drain pipe extends out the bottom of the
grill. The drip pan should be sitting level in the brackets.
M&W-7
5. drain pipe & drain valve
6. cooking grid
7. drip bucket
8. control knobs (allen wrench)
Wrangler only
G. Place your cooking grid into the grill.
H. Install the brass drain valve onto the drain pipe, hand tighten. DO
NOT OVERTIGHTEN WITH A WRENCH OR PLIERS. (You may need
to remove the valve ocassionaly for grill cleaning. Hang the drip bucket.
I. Install the control knobs. Press the black igniter knob onto the post
on the left firmly until it clicks into place. Place the silver gas control
knob onto the gas valve stem and secure the set screw through the
opening on the bottom of the control knob using the small allen wrench
provided.
Tank Installation
See tank installation instructions on previous page
6E
6F
6G
6H
Use the provided allen
wrench to tighten the set
screw through the opening on
the bottom of the gas control
knob