Mitsubishi Electric FR-E500 Instruction Manual page 84

Param-
Func-
eter
tion
Number
FM terminal calibration
900
(Note 9)
AM terminal calibration
901
(Note 10)
Frequency setting voltage
902
bias
Frequency setting voltage
903
gain
Frequency setting current
904
bias
Frequency setting current
905
gain
990
Parameter for option (FR-PU02-
991
Note: 1. Indicates the parameter of which setting is ignored when the general-
purpose magnetic flux vector control mode is selected.
2. Since calibration is made before shipment from the factory, the settings differ
slightly between inverters. The inverter is preset to provide a frequency
slightly higher than 60Hz.
3. When the control panel is used and the setting is 100Hz or more, the setting
increments are 0.1Hz.
4. The setting depends on the inverter capacity: (0.1K to 3.7K)/(5.5K to 7.5K).
5. Set to 85% of the rated inverter current for the 0.1K to 0.75K.
6. If "2" is set in Pr. 77 (parameter write inhibit selection), the setting cannot be
changed during operation.
7. The half-tone screened parameters allow their settings to be changed during
operation if "0" (factory setting) has been set in Pr. 77 (parameter write
inhibit selection). (However, the Pr. 72 value may be changed during PU
operation only.)
8. The setting range changes with the inverter: 0.2kW to 7.5kW, 9999 for the
400V class.
9. Pr. 249 is not available for the 400V class.
10. Setting may be made on the 400V class inverter only.
11. The setting depends on the inverter capacity: 4% for the FR-E540-5.5K and
7.5K-NA.
Setting
Name
Range


0 to
10V
0 to
10V
0 to
20mA
0 to
20mA
).
02
69
Minimum
Setting
Increments


0 to
0.01Hz
60Hz
1 to
0.01Hz
400Hz
0 to
0.01Hz
60Hz
1 to
0.01Hz
400Hz
PARAMETERS
Custo-
Factory Refer
mer
Setting To:
Setting

153

155
0V 0Hz 157
5V 60Hz 157
4
0Hz 157
mA
20
60Hz 157
mA
4