Furuno NX-700A Operator's Manual page 51

Fabricate these cables as below to connect to the receiver unit.
How to use J402 and 403 connector
1. Insert the terminal opener in connector.
2. Insert a wire in terminal while pressing and holding the terminal opener.
3. Release the terminal opener. Pull wire to confirm firmly set it is in terminal
board.
Antenna cable
Be sure to leave some slack in the cable for future service and maintenance.
For RG-10/U-Y cable
When using the coaxial cable, type RG-10/U-Y (or equivalent), attach the
FM-MP-7 connector (supplied as installation material) as below.
1. Remove the sheath by 30 mm.
2. Bare 23 mm of the center conductor. Trim braided shield by 5 mm and tin.
3. Slide coupling ring onto cable.
4. Screw the plug assembly on the cable.
5. Solder plug assembly to braided shield through solder holes. Solder contact
sleeve to conductor.
6. Screw coupling ring into plug assembly.
30 mm
Sheath
5 mm
Braided shield
Insulator
Wire
2 mm
Conductor
100 mm
Terminal opener
Plug assembly
Solder both
Coupling ring
sides of hole.
4. INSTALLATION
5 mm
Contact sleeve
Solder here.
Cut conductor here.
4-7