Antenna Unit; Printer (Nx-700B Only) - Furuno NX-700A Operator's Manual

4. INSTALLATION
4.3

Antenna Unit

Mounting considerations
Install the antenna unit referring to the antenna installation diagram at the back
of this manual. When selecting a mounting location for the antenna unit, keep in
mind the following points:
• Do not shorten the antenna cable.
• The NX-700 contains a very sensitive receiver. To avoid mutual interface with
other radio equipment, do not install this unit near an SSB/VHF/CB
radiotelephone.
• When fixing the antenna cable to the mast with the cable tie, wrap the vinyl
sheet between the cable and mast to protect the cable from injury.
4.4

Printer (NX-700B only)

Prepare the printer by locally as shown below for the NX-700B.
-Serial printer
-Baud Rate: 9600 bps
-Character length: 8 bit
-Parity: No
-X control: XON/XOFF
-32 characters/line or more
4-4
Cable tie
Vinyl sheet
(Local supply)
(Local supply)